Title: Wheel arch liner | |
Dodge50 > Technical section > Technical Specs | Go to subcategory: |
Author | Content |
merloman | |
Date Posted:25/08/2013 02:25:37Copy HTML Anyone ever lined rb arches to keep the rust away looking on some advice for best way
Rot
|
|
Karrier | Share to: #1 |
Re:Wheel arch liner Date Posted:30/08/2013 06:36:00Copy HTML Not on an RB but on my bus, I lined them with ali sheeting 1.5mm thick, i tac welded some steel mounting plates that were about 35mm x 60mm cut from 2mm steel sheet around the wheelarch and pop riveted the ali sheeting on to them (cutting, manipulating the sheeting to fit as i went) then when happy with it I covered it in carbon fiber sheeting (I had been given a load so wanted to use some), then painted over with that black gunky undearseal stuff, did the job a good un.
"Nothing travels faster than the speed of light with the possible exception of bad news, which obeys its own special laws."
Douglas Adams
|
DATINFORMATION: dodge50.co.uk takes no responsibility for any mistakes or advice given, it's up to you if you take it or not, remember, All material is copyright dodge50.co.uk 2002-2018 unless it's someone else's and it has been begged, borrowed or made up.
DISCLAIMER: Any libel or mistakes in messages that are written by members of the community, inc the admin's and owner of this site, dodge50.co.uk takes no responsibility for them, you need to contact the author and have a moan / send a writ / agree. (delete as you see fit) Blah Blah Blah Blah Blah Blah.......Etc.......Etc...........